Specialize in Compression molds
The press usually consists of the upper and lower halves of the mould placed between two heated plates. Pre-heated SMC is placed into the lower half of the mould. The upper plate is then lowered, applying up to 2000 psi of pressure to the mould. Consistent application of heat and pressure causes the SMC to spread and properly fill every part of the mould.
Contact US
Email: [email protected]
Tel: +86 576 84616076
Fax: +86 576 84616079
Mobile: +86 13906573507(Mr. Wang)
Address: No.35-1, Qingfeng Road, North Industrial Estate, HuangYan, Zhejiang,China.